Status Information Field Settings - Zhone IMACS 8000 User Manual

FXO Card
TYPE
The Type information field shows the current status of the signal field selected on the main
FXO card screen for this port. Valid settings for both fxo and fxodn modes are loop (loop), gs
(ground start), lp-fd (loop start-forward disconnect) and R2 (R2). Valid settings for the dpt
mode are dpt (dial pulse terminating), R2 (R2), i-R2 (immediate R2), and dp-em (Dial Pulse
Electromechanical). The only valid setting for the mrd mode is mrd (manual ringdown).
STATUS
The Status information field shows the current status of the port Table 13-5 lists and describes
all of the possible conditions that are reported in this field.
Setting
stdby
W stb
W tst
W OOS
noWAN
call
busy
idle
TC
test
maint
Voice Cards
Table 13-5. Status Information Field Settings
The FXO port is in standby.
The WAN card to which the FXO port is assigned is in standby.
The WAN card to which the FXO port is assigned is under test.
The WAN card to which the FXO port is assigned is out of service.
No WAN card is configured in the slot to which the FXO port is assigned.
Call setup is in progress.
Call is in progress.
No call in progress (port is available for a call).
Port is in Trunk Conditioning because a CGA alarm occurred on the
associated WAN port.
Port is under test (i.e., you are actively controlling the circuit by setting
values for Tx ABCD or Rx ABCD).
The port is in a maintenance condition.
FXO Card User Screens and Settings
Meaning
13-15