Snmp; Ds0 Naming; Nvram Restore Screen - Zhone IMACS 8000 User Manual

Running Head

DS0 Naming

When NVRAM is restored via TFTP or from FLASH, the entire image is transferred including
the circuit name table. The circuit name table shown as Xcon Names has been added to the
selections to allow ascii restore as shown in the figure below.
Upon restoring the Xcon Names table, changed circuit names will be restored into NVRAM
for recognition whenever the resource using it is next changed.
To change a circuit name permanently using NBR, change the circuit name in both the Xcon
Names and the Xcon Names selections. Changing the names in the Xcon table alone will only
preserve the name until next time the resource holding it is changed.

5.17.3 SNMP

Circuit names can also be configured using SNMP. The circuit name field in the Xcon ViewAll
table supports SNMP Set commands.
5.18 DS0 Naming
This feature is designed to allow the user to assign a name to DS0 connections. Starting in
CPU 7.1.2, we now allow for the user to assign a name to a DS0 termination on the IMACS.
We support this naming for FXS, E&M, SRU, OHSU, Bridge and HSU terminations. The
method that we use for this is similar to all the supported cards, so for simplicity we will use
the E&M card as a sample. Figure 5-33 below shows the E&M standard provisioning screen.
5-48
System Configuration and Operation
Figure 5-32.NVRAM Restore Screen
Model No.
Reference Guide