Assigning Multiple Time Slots To A Port; Typical E&M Card Time Slot Assignments - Zhone IMACS 8000 User Manual

System Configuration and Operation
5. Change the STATE of the port from stdby to actv.
6. Repeat steps 2 through 5 for the remaining card ports, to assign time slots to them.
7. Press "s" to save your settings, using the Save command in the Card Main Screen.
Figure 5-21.Typical E&M Card Time Slot Assignments

5.16.2 Assigning Multiple Time Slots to a Port

Figure 5-22 shows the HSU Card Main Screen for the time slot assignment example. Assign
time slots to this card as follows:
1. From the Main Screen, select the desired HSU card and press <Enter>.
2. Select the WAN port to which you want to assign the HSU port. In Figure 5-22, this
port is W4-1 (for WAN 4, port 1) for ports 1 and 3, and W4-2 (for WAN 4, port 2) for
ports 2 and 4.
3. Select the TS table. All time slots of the selected WAN port appear at the bottom of the
screen. These are 1 to 24 for a T1 port, or 1 to 31 for an E1 port.
Reference Guide
Assigning Time Slots
5-39