Ethernet Screen For Ipr*4 Card; Ipr*4 10/100Bt Ethernet Menu Option Settings And Defaults - Zhone IMACS 8000 User Manual

Running Head
IPR*4PPP Configuration Screens and Settings
release in use, some of the field actions (such as State, Interface name and/or Default gateway)
will update all four jacks. The system will prompt to apply the change to all the affected jacks
when the change taking place affects all four jacks.
The IPR*4 card uses ethernet jack 1 as the base address for the router card. The first ethernet
jack interface must have an IP address assigned to it, and be active. Changing the status of
the first ethernet jack will result in a card restart. This restart is required to allow for proper
handling of messages to and from the card. The system will prompt when placing the first
ethernet jack into a standby or active status that the card will perform a restart. This restart is
executed automatically by the system once the jack is made active, and the change is saved.
The other three jacks - numbered 2 through 4 - do not have this constraint, and can be removed
and placed back in service without the need to reset the entire card.
Table 21-6. IPR*4 10/100BT Ethernet Menu Option Settings and Defaults
Parameter
STATE
DEFAULT GATEWAY
INTERFACE NAME
SPEED
DUPLEX
IP MTU
RIP Rx
RIP Tx
SH
21-28
Figure 21-17.Ethernet screen for IPR*4 card
actv stdby
IP address - 0.0.0.0
user selectable
10 100 auto
half full
1500
off on
off v1 v2
yes no
User Options
Model No.
IPR*4 Router Card
Default
stdby
0.0.0.0
none
auto
half
1500
on
v2
yes
Server Cards