Pwe Card Main Screen; Pseudowire To Wan Associations - Zhone IMACS 8000 User Manual

Running Head
PWE Card User Screens and Settings
The PWE main screen is split into two sections, bordered on the top and bottom with
information and options. The screen displays all available facilities and provisioning for the
PWE uplink. Along the top border can be found the software Version of the card, in this case
version 1.2.1. On the bottom border of the screen in inverse video are the various options
covered in Table 24-3. The main two sections of the card display provide access to the
provisioning and current status of the PWE card. The upper section displays the card IP
address and netmask, as well as the gateway address, the MAC address of the card and how
the card is communicating. The lower section displays the eight available T1/E1 facilities
dropping onto the IMACS backplane. In the screen above, network parameters have been
chosen to indicate the card IP address, the choice to use the SFP instead of the RJ45, and also
the user has opted to change the WAN appearance of 2-2 (PW4) to a Pseudowire path.
Presently the WAN associations are hard-coded. These relationships are shown in Table 24-1
below.
24-6
Figure 24-5.PWE Card Main Screen
Table 24-1. Pseudowire to WAN associations
PW1 WAN 1-1
PW2 WAN 1-2
PW3 WAN 2-1
PW4 WAN 2-2
PW5 WAN 3-1
PW6 WAN 3-2
PW7 WAN 4-1
PW8 WAN 4-2
Model No.
PWE Card
Server Cards