Zhone IMACS 8000 User Manual page 781

RATE (compression rate, ADPCM) 11-9
RX TLP (receive TLP) 11-7
SIG CONV (signaling conversion) 11-9
SIGNAL (choose signaling type) 11-6
STATE (activating a port) 11-5
TC CGA (trunk conditioning) 11-7
TS (assign time slot) 11-6
TX TLP (transmit TLP) 11-7
WAN/SRV (assign WAN or server port) 11-5
WINK (duration of wink) 11-9
WK DLY (wink delay time) 11-9
Configuring the FXS card
ADPCM (assign an ADPCM card) 10-12
CODING (PCM companding) 10-10
description 10-3
HYBRID (set line build-out) 10-11
LB (loopback on/off) 10-10
MODE (choose signaling mode) 10-6
PATTRN (send test signal) 10-11
RATE (compression rate, ADPCM) 10-12
RINGBK (send ringback tone) 10-11
RX TLP (receive TLP) 10-9
SIG CONV (convert signaling bits) 10-11
STATE (activating a port) 10-5
TC CGA (trunk conditioning) 10-10
TS (assign time slot) 10-5
TX TLP (transmit TLP) 10-9
TYPE (choose signaling type toward CPE) 10-6
WAN/SRV (assign WAN or server port) 10-5
Configuring the Interface card
user interface ports 6-22
Configuring the OCU-DP card
description 15-3
Configuring WAN cards
T1 CSU and DSX operation 7-20
Connectors and pinouts C-30
ALR 4+4 (S 60) card C-25
E&M 4W*8 (S 60) card C-26, C-27
FXS 2W*8-6 (S 60) card C-29
OCU-DP 5 (S 60) card C-57
CPU card
changing passwords 5-10
configuration 5-6
installation 5-3
other configuration settings 5-13
TCP/IP management 5-20
troubleshooting 5-60
Cross-connecting time slots
deleting a connection 3-91
signaling conversion 3-86