Nx64 Screen Options And Defaults - Zhone IMACS 8000 User Manual

Running Head
IP Packet Routing
Main
Parameter
STATE
WAN/SERV
TS
FORMAT
RATE
MTU
STATE
The state indicates whether the port is enabled or disabled. Upon activation all parameters are
validated. The selected IP address and netmask must be valid. The WAN must be available,
and the selected combination of time slots must be available to activate the port. Default state
is stdby.
WAN
This parameter indicates which WAN/SERV the nX64 can be connected to. The WAN
selected should be available. If the selected WAN is removed and deleted, the port should be
set to stdby. Default WAN is none.
TS
This table shows 24 selectable time slots when configured for T1, 31 selectable time slots
when configured for E1. Time slot 16 is only available if TS16 is set to nos from the WAN
screen. No time slots are selected as default.
FORMAT
The format indicates which format is selected for the given nX64 communications port.
Possible options are HDLC, Frame Relay and Ethernet. Ethernet is only allowed for
communications port1. Default setting is HDLC.
7-48
Returns to the CPU card main screen. If changes are made to settings and
not saved, you will be prompted to save or lose changes.
Table 7-16. nX64 Screen Options and Defaults
actv stdby
none wan (w1-1, w1-2, w2-1, w2-2, w3-1,
w3-2, w4-1, w4-2)
n/a 1-24(T1) 1-31(E1)
hdlc fr ether
56k 64k
<128 - 1500>
User Options
Model No.
CPU Card
Default
stdby
none
no
hdlc
64k
240
System Cards