Status Information Field Settings - Zhone IMACS 8000 User Manual

E&M Card
Setting
stdby
W stb
W tst
W OOS
noWAN
OOS
call
busy
idle
TC
test
maint
E&M Signaling Type
This field shows the card's current on-board switch settings, which define the type of E&M
signaling used on each port. If necessary, remove the card and reset the switches as previously
described until the desired signaling type appears in the screen. The E&M Signaling types are
I, II, IV, and V, followed by a "-t" if the card is optioned to provide trunk signaling.
Voice Cards
Table 11-7. Status Information Field Settings
The E&M port is in standby.
The WAN card to which the E&M port is assigned is in standby.
The WAN card to which the E&M port is assigned is under test.
The WAN card to which the E&M port is assigned is Out Of Service.
No WAN card is configured in the slot to which the E&M port is assigned.
The E&M card is out of service.
Call set-up is in progress.
Call is in progress.
No call is in progress; circuit is available.
The E&M circuit is undergoing Trunk Conditioning because a CGA alarm
is in progress on the associated WAN port.
The port is under test (i.e., you are actively controlling the circuit by setting
values for Tx ABCD, Rx ABCD, or E-lead).
Maint is a status that tells that a specific port is under maintenance.
E&M Card User Screens and Settings
Meaning
11-15