Main Screen Option Settings; Pwe Card Setting Options And Defaults - Zhone IMACS 8000 User Manual

PWE Card
The basic philosophy of the Pseudowire card offering is to keep all the user (DS0 level)
provisioning the same for individual circuits to the WAN, and then convert the WAN from an
electrical to a virtual facility. By this method there is no need to introduce or learn a new
cross-connect methodology, but rather make all the connections as normally done on the
IMACS user cards and then convert the WAN facility itself from an electrical transport to an
IP-centric transport out the faceplate of the PWE card.
Table 24-3 below shows these PWE screen settings, the options and the default settings.
Parameter
STATE
STATUS
IP ADDR
NET MASK
DEFAULT GW
SPEED
CONNECTOR
MAC ADDR
GLOBAL SETTINGS
TYPE
STATE
WAN
STATUS
CLK
CLK STATUS

24.3.2 Main Screen Option Settings

Following is each parameter in more detail.
Server Cards
Table 24-2. PWE Card Setting Options and Defaults
User Options
stdby actv rdnt
Down Up (rate full)
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
auto 100/fd
rj45 sfp
Display only
Display only
wan pwan
- stdby actv
Display only. Will show
information once a
Pseudowire is provisioned
- down up
- comm adapt
- acq locked
PWE Card User Screens and Settings
stdby
Down, read only field
0.0.0.0
0.0.0.0
0.0.0.0
auto
rj45
Read only, the card's MAC address
Defaults chosen at card bring-up
wan
- (not applicable)
- (not applicable)
- (not applicable).
- (not applicable).
- (not applicable).
Default
24-7