E&M Card User Screens And Settings; E&M Card Main Screen; Typical E&M Card Main Screen - Zhone IMACS 8000 User Manual

E&M Card
11.3 E&M Card User Screens and Settings
11.3.1 E&M Card Main Screen
You must configure the E&M card for operation after installing it in the system chassis. This
is done from the E&M Main Card Screen, which is shown in Figure 11-2. To go to that screen,
highlight the desired card on the System Main Screen, then press <Enter>. The E&M Card
Main Screen shows numerous columns of settings, each for one port of the card.
The bottom highlighted line of this screen shows various actions that you can perform from
this screen. You perform the desired action by pressing the associated uppercase letter key.
Table 11-3 summarizes these actions. For example, after you configure the E&M card ports,
press "s" to save your settings.
Voice Cards
Figure 11-2.Typical E&M Card Main Screen
E&M Card User Screens and Settings
11-5