Test Screen; Typical Wan Card Test Screen; Test Screen Actions; Wan Card Test Screen Options - Zhone IMACS 8000 User Manual

Running Head
WAN Card User Screens and Settings
9.4.6

Test Screen

Pressing "t" (Test command) in the WAN Card Main Screen brings up the screen shown in
Figure 9-24. From this screen, you can create test situations between WAN cards or between
a single WAN card and data test equipment at a remote site. Table 9-10 lists the actions you
can perform from the bottom line of this screen. Table 9-11 lists the settings controlled on this
screen along with their possible values.
Action
Save Saves changes to settings.
Undo Returns all settings to the last saved state.
Refresh Updates certain time-related information fields that are not automatically
updated (i.e., performance and test data).
Insert Err Allows you to manually insert a single bit error into the data signal. This does
not cause a CRC error.
Clear Clears the Test Screen and resets all counters to zero.
Main Returns to the WAN Card Main Screen. If changes are made to settings and
not saved, you will be prompted to save or abandon those changes.
Parameter
BERT off
SYNC information only–no user options
BE information only–no user options
9-44
Figure 9-24.Typical WAN Card Test Screen
Table 9-10. Test Screen Actions
Table 9-11. WAN Card Test Screen Options
User Options
mark space 1:1 1:7 3:24 qrss
Function
lp-up lp-dn
Model No.
WAN Card
Notes Default
1 off
System Cards