Syslog Server Level; Syslog Level - Zhone IMACS 8000 User Manual

CPU Card
To setup up the SYSLOG service on the IMACS, the user must log in with administrative
privileges. Position on the active CPU, and press carriage return. On the CPU XCON screen,
then hit 'I' for tcp/Ip and the screen below will appear.
:
Once at this level, simply hit 'L" to access the SYSLOG server setup screen, as shown in the
following illustration.
The user can then activate the feature, and input up to two devices for event collection. Use of
the SYSLOG feature does require the use of IP addressing, so an IP network to the IMACS
must be established and maintained. Once established, the facility above allows for the
generation of a test message to be sent to the SYSLOG collector, to confirm connectivity.
Below is the result of that test using the 3CDaemon tool:
System Cards
Figure 7-11.SYSLOG server level
Figure 7-12.SYSLOG level
TCP/IP Network Management
7-25