Fxo Card User Screens And Settings; Fxo Card Main Screen; Typical Fxo Card Main Screen - Zhone IMACS 8000 User Manual

FXO Card

13.3 FXO Card User Screens and Settings

13.3.1 FXO Card Main Screen

The FXO Card must be configured for operation after installing it into the system chassis. This
is done from the FXO Card Main Screen (see Figure 13-2). To go to that screen, highlight the
desired card in the System Main Screen and press <Enter>. This screen shows one
configuration column for each port on the card.
The bottom highlighted line of this screen shows various actions that you can perform from
the screen. You perform the desired action by pressing the associated uppercase letter key.
Table 13-1 summarizes these actions. For example, after you configure the FXO card ports,
press "s" to save your settings.
Voice Cards
Figure 13-2.Typical FXO Card Main Screen
FXO Card User Screens and Settings
13-3