Control: Simatic Batch Os Process Cell - Siemens SIMATIC BATCH Operating Manual

BATCH OS controls
11.3 Operations in process mode
Note
Each master control can only be connected to one SIMATIC BATCH project. If you want to
connect another BATCH project, the existing connection will be closed. If several masters are
connected to the same project through different communication channels and a master closes
this connection, all the other masters will lose the connection.
11.3.2

Control: SIMATIC BATCH OS Process Cell

What is the purpose of the "SIMATIC BATCH OS Process Cell" control?
The control shows the Batch process cell for the selected BATCH project. It is used for batch
planning, batch creation and even batch operator control. The OS control is divided into two
areas, the navigation area on the left and the display area on the right. The sizes of the two
areas can be individually adjusted. The display area has the tabs "Entire list", "Planning list",
"Status list", "Results list" and "Favorites". Operator functions for batch operation are available
in both the toolbar and in the shortcut menu.
Information in the control
Navigation area: The navigation area shows the folder structure of your Batch process cell.
The folder structure with names and contents is taken from the activated BATCH project. The
top folder has the name of your Batch process cell. The folders arranged underneath
correspond to the order category folders with the order folders created therein. Each order
folder is displayed with name, folder symbol, and status symbol. The actual status of the order
is indicated with the symbols of the order folders. The following symbols are assigned to an
order:
Table 11-1
Symbol Status
600
Status symbols of the order folders
Order inactive
Order active
Order held
Order completed
You can find additional information on the "Completed" status in the section "Status display
at the order folder (Page 439)".
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA