Parameterslistcolumnwidth - Siemens SIMATIC BATCH Operating Manual

BATCH OS controls
11.5 Control properties references
This attribute defines the sequence of the table columns in the "Parameters" tab of the
properties dialog and in the SIMATIC BATCH OS Properties control. If values are not specified,
the corresponding columns are not displayed in the control.
The following columns are available:
Column name
Name
Type
Data type
Low limit
Setpoint value
High limit
Actual value
Quality (1)
Unit of measure
Scaling
Material
Source
Destination
Reference
Location
Location ID
Description
Time remaining
Effective immediately
Formula
(1) The Quality column is not supported and exists only for compatibility reasons.
Default: 1;2;3;4;5;6;7;9;10;11;12;13;14;15;16;17;19
The attribute can be dynamized with the ParametersListColumnOrderAndVisibility name.
11.5.3.10

ParametersListColumnWidth

String.
654
Value
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Note: To make the "Time remaining" table column
visible in the control, enter the assigned value 18
manually.
19
22
Note: To make the "Formula" table column visible
in the control, enter the assigned value 22 man‐
ually.
Operating Manual, 02/2016, A5E35958174-AA
SIMATIC BATCH V8.2