Parameterslistcolumnresizeenabled; Parameterslistcolumnfiltervisible - Siemens SIMATIC BATCH Operating Manual

This attribute defines the width of the table columns in the "Parameters" tab of the properties
dialog and in the SIMATIC BATCH OS Properties control. The default values for column width
are as follows:
Table column
Name
Type
Data type
Low limit
Low limit of the recipe
Setpoint value
High limit of the recipe
High limit
Actual value
Unit of measure
Scaling
Material
Source
Objective
Reference
Location
Location ID
Description
Immediately
Time remaining
Formula
Quality (1)
(1) The Quality column is not supported and exists only for compatibility reasons.
The values are entered, separated by a semicolon.
The attribute can be dynamized with the ParametersListColumnWidth name.
11.5.3.11

ParametersListColumnResizeEnabled

Boolean variable.
This attribute specifies whether or not the column width in the "Parameters" tab of the
properties dialog and in the SIMATIC BATCH OS Properties control can be adapted. If Yes is
set, an operator can adapt the column width in process mode.
Default: Yes, the column width can be changed.
The attribute can be dynamized with the ParametersListColumnResizeEnabled name.
11.5.3.12

ParametersListColumnFilterVisible

Boolean variable.
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA
11.5 Control properties references
Column width in pixels
150
75
75
75
75
75
75
50
75
75
75
100
75
75
70
50
150
75
40
75
75
75
BATCH OS controls
655