Siemens SIMATIC BATCH Operating Manual page 393

Legend
1. The error status of a batch depends on the recipe procedure elements (RPEs).
2. For later use.
3. After "Release", can be reached from all statuses except "abort" and "completed", not using
additional ID.
4. After "Release" can be reached from all statuses except "abort", "aborting", "stopped" and
"completed", not using additional ID.
5. Depending on the project settings in the "Batches" tab, "Allow deleting of completed,
unarchived batches".
6. In addition: "archived", "archiving", "completed" and "completing", only additional ID.
Note
Status changes of a batch
1. ERROR" is an additional label that can appear in any status from "WAITING" onwards.
Once the cause of the problem has been resolved, the batch can be resumed using
"RESUME", aborted using "ABORT", or stopped using "STOP".
2. A batch is only in the "WAITING" status when it is waiting for its first unit to be allocated.
3. CLOSED" and "ARCHIVED" are additional labels, which continue to show whether the
batch was completed or aborted.
4. "Batch valid" is an interim status in normal conditions and a status in an error case,
assuming a validity check was successfully performed before the error occurred.
5. The additional label "archiving" is used only in connection with the "Prompt archiving"
technology.
Additional information
Status of the batches (Page 372)
States of the batch steps (Page 427)
States of a transition (Page 426)
PH Archive server - Prompt archiving (Page 471)
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA
BATCH Control Center
9.8 Batch control
393