General - Siemens SIMATIC BATCH Operating Manual

Context help references
14.1 Dialogs
14.1.2.2

General

Introduction
In the "General" folder, you edit the basic project settings for the appearance and range of
functions of SIMATIC BATCH.
Allow simultaneous ROPs
If you configure simultaneous recipe operations (ROPs) in master recipes, set the value of this
property to "Yes". The "Insert simultaneous branch" command can then be selected in the
Recipe Editor. If you set the "Allow simultaneous ROPs" property to "No", only chains of ROPs
can be configured. In this case, multiple ROPs are never simultaneously active.
The default setting of this property is "Yes".
Allow editing of recipes with "Release revoked/invalid" status
The setting "No" prevents recipes whose status is "Release revoked/invalid" from being
released again under the same name/version. This setting only affects recipes that are
released for production.
The default setting of this property is "Yes".
Allow jump beyond synchronization lines
If you set the value of this property to "Yes", jump destinations beyond synchronization lines
are permitted.
Additional information:
● Jump (Insert menu) (Page 548)
● Monitoring (Insert menu) (Page 541)
The default setting of this property is "No".
Transfer setpoints when changing from manual to automatic
If you change an active phase from manual to automatic mode, the SFC type initially continues
to work with the setpoints that were set in manual mode. In this case, SIMATIC BATCH has
so far supplied no setpoints for the phase. If you set the value of this property to "Yes", at the
changeover from manual to automatic mode, SIMATIC BATCH delivers the setpoints to the
phase, provided that the SFC type and SIMATIC BATCH have matching control strategies.
This instructs the SFC type to adopt the setpoints from SIMATIC BATCH in automatic mode.
The default setting of this property is "No".
728
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA