Siemens SIMATIC BATCH Operating Manual page 618

BATCH OS controls
11.3 Operations in process mode
Favorites of the control recipe
The favorites of the control recipe are based on the master recipe used. This means that if
another control recipe based on the same master recipe is opened, the recipe-related favorites
are made available to you as well.
Operation of the control in process mode
The requirements for operation in process mode:
● The control has been inserted in a process picture and appropriately configured.
● WinCC Runtime has been started and the process picture with the BATCH controls is
displayed.
● A BATCH project has been connected via the master.
● SIMATIC BATCH has been started on the PC from which the BATCH project originates.
Several process operations in the control are listed below:
1. Update your project data with the function provided for this in the toolbar.
2. Display the planned batch in the "SIMATIC BATCH OS Properties" control. To do so,
double-click the appropriate batch in the planning list in the "SIMATIC BATCH OS Process
Cell" control.
3. Release the batch. Select the batch in the navigation area and select the "Release batch"
command in the shortcut menu.
4. Start the released batch. Select the batch in the navigation area and select the "Start batch"
command in the shortcut menu.
5. Watch the batch execution on the "Control recipe" tab and in the control recipe view in the
display area. Open all folders up to the recipe phase level to display the respective status.
6. Hold a recipe element immediately. Select an ROP in the navigation area and select the
"Hold step" command in the shortcut menu.
7. Resume the immediately held recipe element. Select the held recipe element and click the
"Resume batch" command in the shortcut menu.
8. Change a recipe parameter. Select the corresponding recipe phase in the navigation area
and open the "Parameters" tab. Enter a new setpoint for the desired parameter in the
"Setpoint" table column.
9. Change the unit allocation. Select the corresponding unit of your batch in the navigation
area and open the "Allocation" tab in the display area. Select the desired unit in the selection
box of the "Unit" column.
You have now used the most important commands and procedures in this control.
Additional information
Applications in process mode (Page 624)
618
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA