Configuration Examples; Example Configuration 1 - Existing Network With Static Addressing; Figure 3-1 Example Configuration 1 - Existing Network With Static Ip Address; Section 4 Example Configurations - NEC Univerge SV9100 Manual

Issue 2.0
S 3 C
ECTION ONFIGURATION
The following configuration examples illustrate a typical network configuration for an
existing network that uses a static address and a typical configuration for a new
network that uses a dynamic address.
3.1
SV9100 Networking Manual
E
XAMPLES
Example Configuration 1 - Existing Network with Static
Addressing
Figure 3-1 Example Configuration 1 - Existing Network with Static IP Address on
page 3-3 shows a typical network configuration that uses Static IP Addressing.
Each client device has a manually assigned IP address in the 192.168.1.0/24
network (i.e., 192.168.1.1 to 192.168.1.254 with a subnet mask of
255.255.255.0). They also have a default gateway address configured
(192.168.1.254) this allows the device to route packets to destinations that exist
outside of their own LAN.

Figure 3-1 Example Configuration 1 - Existing Network with Static IP Address

192.168.1.50
Router
(Default Gateway)
192.168.1.254
Switch
(Switched Hub)
192.168.10.11
192.168.1.32
WAN,
Internet, etc.
192.168.1.10
3-3