Table 10-2 Cpu Reset Programs - NEC Univerge SV9100 Manual

Issue 2.0
3.3
SV9100 Networking Manual
In-Mail and VRS use the VMDB of the Primary (Main) site.

APSU can be installed in the Secondary (Remote) System, however

the NetLink time zone follows the Primary (Main) System.
When installing a Secondary System in a Netlink network and the

Secondary System has GCD-LCA blades installed, the GCD-LCA
blades will come online and assign ports before any GCD-DLCA
blades are assigned.
Secondary systems must follow the primary CPU software settings

for Mu-law/A-law within the country where the primary system is
located. SV9100 NetLink connections are only supported within the
same countries/areas. For example, the SV9100 can be connected
via NetLink between the US and Canada, however the SV9100
cannot be connected via NetLink with systems in other countries
(e.g., Mexico or the U.K.).
Synchronous Ringing via NetLink is not supported.

Always connect to the Primary System when using PCPro.

When using K-CCIS - T1 in a Netlink system, the CCTA blade is only

supported in the primary system.
The following programs require a reset after making a change using

PCPro, WebPro or Handset programming:

Table 10-2 CPU Reset Programs

Program
10-12-01
10-12-02
10-12-09
51-01-01
51-15
84-03-06
90-04
90-58
10-46-07
84-23
DSP
(PB Receiver, Dial Tone Detector, Caller ID Detector, Caller ID Sender, MF
Receiver).
When Changed Using
Handset, WebPro, PCPro
Handset, WebPro, PCPro
Handset, WebPro, PCPro
Handset, WebPro, PCPro
WebPro, Handset Programming
Handset, WebPro, PCPro
Handset Programming
Handset Programming
PcPro
Handset, WebPro, PCPro
10-13