Configuration Examples - NEC Bull NovaScale R620 User Manual

Configuration Examples

The following describes examples of configuration required to use software-link features or for system operations.
Link with Management Software
To control power supply of the server with ESMPRO Manager via the network
<Using the LAN connector on the motherboard>
Select [Advanced]→ [Advanced Chipset Control]→ [Wake On LAN]→ [Enabled]
<Using the PCI LAN card>
Select [Advanced]→ [Advanced Chipset Control]→ [Wake On PME]→ [Enabled]
UPS
To link power supply with the UPS
To power on the server when power is supplied from the UPS
Select [Server] - [AC-LINK] - [Power On].
To keep the server off-powered even when power is supplied from the UPS if the POWER switch was used to
power off
Select [Server] - [AC-LINK] - [Last State].
To keep the server off-powered even when power is supplied from the UPS
Select [Server] - [AC-LINK] - [StayOff].
Keyboard
To set Num Lock and key repeat
Select [Advanced] - [NumLock].
Security
To set passwords on the BIOS level
Select [Security] - [Set Supervisor Password] and enter a password.
Set Supervisor password first, then User password.
To enable/disable the POWER switch
Select [Security] - [Switch Inhibit] - [Disabled]. (POWER switch enabled)
Select [Security] - [Switch Inhibit] - [Enabled]. (POWER switch disabled)
IMPORTANT:
Masking the POWER switch disables forced shutdown as well as power on/off using the POWER switch.
NovaScale R620 User Guide
4-5