Configuration Examples - NEC NovaScale R630 User Manual

Configuration Examples

The following describes examples of configuration required to use software-link features or for system operations.
UPS
To link power supply with the UPS
To power on the server when power is supplied from the UPS
Select [Server] - [AC-LINK] - [Power On].
To keep the server off-powered even when power is supplied from the UPS if the POWER switch was used to
power off
Select [Server] - [AC-LINK] - [Last State].
To keep the server off-powered even when power is supplied from the UPS
Select [Server] - [AC-LINK] - [StayOff].
Keyboard
To set Num Lock and key repeat
Select [Advanced] - [I/O Device Configuration] - [NumLock]
Security
To set passwords on the BIOS level
Select [Security] - [Set Supervisor Password] and enter a password.
Select [Security] - [Set User Password] and enter a password.
Set Supervisor password first, then User password.
Optional PCI–related devices
To enable Option ROM of the PCI card (option) installed on the server
Select [Advanced] - [Option ROM Configuration] - [PCI Slot n (....)] - [Enabled].
n: Slot number to install the board
Boot
To change the boot order of devices connected to the server
Select [Boot] and specify the boot order.
To display POST check results
Select [Advanced] - [Boot-time Diagnostic Screen] - [Enabled].
You can also press Esc while the logo is on the screen to display POST check results.
To control from the HW console
Remote operation via Serial
Select [Server] - [Console Redirection], and make necessary settings.
4-6