Asynchronous Settings - NEC Univerge SV9100 Manual

Be careful when changing the communication server database. If the Primary
System is changed before synchronization, the edited data is lost.
8.1
8.2
10-38

Asynchronous Settings

The following program settings are not updated by the Primary System:
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-45, 51-01, 90-01, 90-09.
SRAM Database
Data in SRAM area is not transferred to Secondary Systems. When Fail-Over
occurs, a terminal may lose DND, Caller ID History, etc.
Related Programming:
51-09-06 : NetLink TCP Port Settings – Database Replication Secondary

System Listening Port
Define the listening port used so the Secondary SV9100 can replicate the
Primary SV9100 database (0~65535).
51-09-07 : NetLink TCP Port Settings – Database Replication Primary System

Detection Port
Define the port used for communication so that the Primary SV9100 may
synchronize the Secondary SV9100 with the program data (0~65535). If 0 is
entered, the port is selected dynamically.
51-16-01 : NetLink System Data Replication Mode Setting – System Data

Replication Mode
Set the replication mode (0 = Disabled, 1 = Setting Time Mode, 2 = Interval
Mode). An entry of 1 replicates the data at the time set in Program 51-16-02. If
this option is set to 2, replication occurs at the time set in Program 51-16-03.
51-16-02 : NetLink System Data Replication Mode Setting – System Data

Replication Time Setting
If Program 51-16-01 is set to 1, set the time to replicate the program data
(0000~2359).
51-16-03 : NetLink System Data Replication Mode Setting – System Data

Replication Interval Setting
If Program 51-16-01 is set to 2, set the time between replicating the program
data (15-1440 minutes).
51-16-04 : NetLink System Data Replication Mode Setting – Replication Time

Stamp
This program displays the last time the program data was replicated. This is
automatically updated when the replication occurs. This option is view-only.
51-16-05 : NetLink System Data Replication Mode Setting – System Data

Replication Wait Time
When a NetLink network is created, this option determines the time the SV9100
waits before replication is started (1~86400 seconds).
Issue 2.0
SV9100 NetLink