NEC Univerge SV9100 Manual page 99

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Programming Example

The following example will use the first two priorities of System A to route 10 digit

local calls out trunk group one of System B and if that fails the call is routed out trunk

group one of System A.

This example assumes the following:

System A has local trunks 1-8 in trunk group 1.

Both systems are already configured for the LAN on which they reside and

have a network route to each other.

Both systems are configured for K-CCISoIP.

System A is assigned point code 1 and 1XX extensions.

System B is assigned point code 2 and 2XX extensions.

While dial analysis can be configured in all systems, for this example only

System A has ARS dial analysis configured.

Table 4-1 Programming Example

IP Trunk Mode CCIS

Starting CCIS Trunk Number

Number of CCIS Trunks to Create.

This will create CCISoIP trunks 9-

First setting data. Put CCISoIP

trunks in trunk group 10.

Second setting data. Set priorities 1-

8 for trunks 9-16.

Enable ARS Services

For table entry 1 enter 5 wildcard

For table entry 1 set service type to

For table entry 1 set additional data

to F-Route Table 2.

Set ARS Treatment 1 to sent the

number including the trunk access

code of 9 to System B.

Closed numbering setup - Set to first

digit of remote system extension

Features and Specifications