Configuration Examples - NEC NovaScale R480 E1 User Manual

Configuration Examples

The following describes examples of the configuration required to use software-link features or for system operations.
Link with Management Software
To link with the temperature monitoring feature of NEC ESMPRO Agent
Select [Server] - [Thermal Sensor] - [Enabled].
To control the power supply of the server with NEC ESMPRO Manager via the network
Select [Advanced] - [Advanced Chipset Control] - [Wake On Lan/PME] - [Enabled].
Select [Server] - [AC-LINK] - [StayOff].
NOTES:
[Wake On Lan/PME] feature is supported by the onboard LAN controller
(1000Base-T/100Base-Tx).
Immediately after AC power is turned on, the [Wake On Lan/PME] feature is enabled
regardless of the BIOS settings.
UPS
To link power supply with the UPS
To power on the server when the power is supplied by the UPS
Select [Server] - [AC-LINK] - [Power On].
To keep the server powered off even when the power is supplied from the UPS when the POWER switch is
used to power off
Select [Server] - [AC-LINK] - [Last State].
To keep the server powered off even when the power is supplied from the UPS
Select [Server] - [AC-LINK] - [StayOff].
Boot
To change the boot order of the devices connected to the server
Select [Boot] and specify the boot order.
To display the POST check results
Select [Advanced] - [Boot-time Diagnostic Screen] - [Enabled].
You can also press Esc while the full-screen logo is displayed to switch to the POST check results.
To control from the HW console
Select [Server] - [Console Redirection] and set each item.
4-4