NEC Univerge SV9100 Manual page 132

Issue 2.0
1.
Remote Office:
No manual operation is required.
S
ERVICE
General:






Restrictions:




SV9100 Networking Manual
- OR -
Press the Night Transfer key on the Attendant Add-On Console.
C
ONDITIONS
A maximum of 16 remote offices can be controlled by one main office.
If Automatic Day/Night Mode Switching is assigned in the main office, all
remote offices change the mode, if assigned.
If the remote office is to be restricted from overriding the Day/Night Mode
setting, the following Memory Blocks should be assigned:
12-01-01 Night Mode Function Setup – Manual Night Service enable

20-07-01 Class of Service Options (Administrator Level) – Manual Night Service

enable
When the remote office is in Night Mode (as assigned in the Centralized
Day/Night Mode - K-CCIS feature), normal Night Mode indications are
provided.
The Night Mode indication is the first word (Night) on the second row of the
multiline terminal LCD. The LED for any Feature Access key assigned for Night
Mode transfer and the Night Mode key on the Attendant console are On.
If the K-CCIS link is not available due to network trouble, the UNIVERGE
SV9100 main office resends the K-CCIS Day/Night Mode switch command
every 16 minutes.
Centralized Day/Night Mode switching from a main office can send a
system-wide K-CCIS Day/Night mode switch command only. Individual Night
Service Groups Mode switching is not supported.
When an UNIVERGE SV9100 receives the K-CCIS Day/Night Mode switch
command from a main office, the remote office changes all Night Service
Groups to the requested mode.
Program 50-03-01 (Destination Point Code Transfer Assignment) must be set
for all offices for the Centralized Day/Night Mode feature.
A NEAX2000 cannot be used as a main office or a tandem office for the
Centralized Day/Night Mode Change (K-CCIS) feature.
4-53