NEC Univerge SV9100 Manual page 124

Issue 2.0
G
UIDE TO
This guide provides a list of associated Programs that support this feature.
For Centralized Billing Installation
Program/ Description/
Item No. Selection
Basic Trunk Data Setup –
Trunk-to-Trunk
14-01-24
Outgoing Caller ID
through Mode
Class of Service Options
20-08-13
(Outgoing Call Service) –
ISDN CLIP
ISDN Calling Party Number
Setup for Trunks
21-12-01
ISDN Calling Party Number
21-13-01
Setup for Extensions
Program/
Description/Selection
Item No.
CCIS System Setting –
50-01-01
CCIS Availability
CCIS Destination System
50-03-01
Settings – Destination
Point Code
CCIS Centralized Billing
50-07-01
Center Office – Destination
Point Code
SV9100 Networking Manual
F P
EATURE ROGRAMMING
Assigned Data
0 = Off
1 = On
Default is 0
0 = Off (Default)
1 = On
Default is 1
Up to 16 digits max.
Default is No Setting
Up to 16 digits max.
Default is No Setting
Assigned Data
0 = Disable
1 = Enable
Default is 0
0~16367
Default is 0
0~16367
Default is 0
Comments
Enable Outgoing Caller ID through Mode for
each CCIS trunk to enable CPN information
to pass through the Tandem Office.
Tandem System Only
Determine if the ISDN calling line identity
presentation and screening indicators are to
be allowed.
Assign each trunk a Calling Party Number.
When a call is made by an extension which
does not have an Extension Calling Number
assigned
(Program 21-13), the system sends the
calling number for the ISDN trunk defined in
21-12.
Assign each extension a Calling Party
Number.
Comments
All CCIS settings lose functionality when 0 is
selected.
Assign the destination transfer point code for
Tandem KTS.
Assign point code for the Centralized Billing Office
PBX.
4-45