Figure 8-35 System Data 84-26: Iple Basic Setup (Dsp) - NEC Univerge SV9100 Manual

Issue 2.0
SV9100 Networking Manual
2. Program 84-26
Assign IP addresses to the DSPs that are to be used. The IP
addresses assigned must be in the same subnet as the address in
Program 10-12-09.
After these commands are uploaded to the CPU, a system reset must
be applied.
Assign an IP address to the IPLE. An IPLE provides 256 voice paths
from IP to TDM & vice versa with appropriate licenses.

Figure 8-35 System Data 84-26: IPLE Basic Setup (DSP)

3. Program 11-02
SIP MLT Stations are assigned to non-equipped hardware ports.
Physical Station ports are assigned automatically from lowest number
ascending as cards are added to the system.
Because of this you should assign SIP MLT Stations starting with the
higher number ports. By default all Station Ports are assigned
numbers in the SV9100. These are easily changed in Program 11-02
to the required station number as long as the leading digit/digits are
set in Program 11-01 as Extension.
Ports are dedicated to VoIP stations in groups of 2. For example, in
the image to the left, if port 504 (Extension 5203) is used for a SIP
MLT station, that group of 2 ports (Ports 503 and 504) is now
dedicated to VoIP use only.
8-63