NEC Univerge SV9100 Manual page 479

Hide thumbs Also See for Univerge SV9100:
Table of Contents

Advertisement

Program
Program Name
Number
15-05-45
IP Telephone Terminal
Basic Data Setup – NAT
Plug and Play
15-05-47
IP Telephone Terminal
Basic Data Setup –
Registration Expire
Timer for NAT
15-05-48
IP Telephone Terminal
Basic Data Setup –
Subscribe Expire Timer
for NAT
84-20-01
SIP Extension Basic
Information Setup –
Registrar/Proxy Port
84-26-01
IPL Basic Setup – IP
Address
84-26-02
IPL Basic Setup – RTP
Port Number
84-26-03
IPL Basic Setup – RTCP
Port Number (RTP Port
Number + 1)
9-12
Description/Comments
This program is valid when
Program 10-46-14 is On (NAT
feature activated).
Select sending RTP port
number to remote Router, use
from negotiation result (0) or
received RTP packet (1).
SV9100 uses this program to
decide a destination port of
RTP transmitting packets from
IPLE to a remote IP terminal.
If "0:OFF" is selected, the
destination port of RTP
transmitting packets will be a
SIP/SDP negotiation
result.(same behavior as
before). If you chose "1:ON",
the destination port of RTP
transmitting packet will be the
same port of a source port of
a receiving RTP packet on
IPLE. IPLE is required.
On a per station basis, this
setting defines the SIP
registration expiry timer.
If this value is set to 0, for a
NAPT terminal, the value in
Program 84-23-01 is applied.
On a per station basis, this
setting defines the SIP
Subscribe expiry timer.
If this value is set to 0, for a
NAPT terminal, the value in
Program 84-23-02 is applied.
Define SIP station Proxy Port. 1~65535
Assign the IP address for
each DSP on the IPLE.
Assign the RTP port number
to be used for each DSP on
the IPLE.
Only even numbered ports
are supported.
Define the TCP port number
for RTCP to use for each
DSP.
Assigned Data
1
0 = Disable
1 = Enable
(default = 0)
X
0 = Disable
60~65535 (sec)
(default = 180)
0 = Disable
60~65535 (sec)
(default = 180)
(default = 5070)
X
xxx.xxx.xxx.xxx
Defaults:
X
Slot 1 = 172.16.0.20
0~65534
Defaults:
RTP Port = 10020
0~65534
Defaults:
RTCP Port = 10021
IP Single Line Telephone (SIP)
Issue 2.0
2
3
X
X
X
X

Advertisement

Table of Contents
loading

Table of Contents