NEC Univerge SV9100 Manual page 371

Issue 2.0
Program Name/Description
Program
Number
15-05-50 IP Telephone Terminal Basic Data Setup –
Peer to Peer Mode
On a per station basis enable or disable Peer to
Peer mode.

For Video Call to function set to 1 (Enable).
20-08-13 Class of Service Options (Outgoing Call
Service) – ISDN CLIP
Determine if the ISDN calling line identity
presentation and screening indicators should
be allowed.
21-17-01 IP Trunk (SIP) Calling Party Number Setup
for Trunk
Assign the Caller Party Number for each IP
trunk. The assigned number is sent to the
central office when the caller places an
outgoing call. If the Calling Party Number is
assigned by both Program 21-17 and Program
21-18/ 21-19, the system uses the entry in
Program 21-18/21-19.
21-19-01 IP Trunk (SIP) Calling Party Number Setup
for Extension
Assign the Calling Party Number for each
extension. The assigned number is sent to the
central office when the caller places an
outgoing call. If the Calling Party Number is
assigned by both Program 21-17 and Program
21-18/Program 21-19, the system uses the data
in Program 21-18/Program 21-19.
22-02-01 Incoming Call Trunk Setup
Assign the incoming trunk type for each trunk.

For the SIP System Interconnection, set each
trunk to 5 (E&M Tie Line).
44-02-01 Dial Analysis Table for ARS/F-Route Access
– Dial
Set the Dial digits for the Pre-Transaction Table
for selecting ARS/F-Route (eight digits
maximum: 1~9 , 0 * # , @ ).

To enter a wild card/don't care digit, press Line
Key 1 to enter an @.
SV9100 Networking Manual
Input Data
0 = Disable
1 = Enable
0 = Off
1 = On
Maximum of 16 digits

(0 ~ 9, , # )
Maximum of 16 digits

(0 ~ 9, , # )
(Profile 1 ~ Profile 2)
Trunks 1 ~ 400
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
Maximum of eight digits.
Level
Default
1 2 3
1

0

No Setting

No Setting

0

No Setting

6-25