Configuration Examples - NEC Express5800/R140a-4 User Manual

4-4 Configuring Your Server

Configuration Examples

The following describes examples of configuration required to use software-link features or for
system operations.
Link with Management Software
To link with the temperature monitoring feature of NEC ESMPRO Agent
Select [Server] - [Thermal Sensor] - [Enabled].
To control power supply of the server with NEC ESMPRO Manager via the network
Select [Advanced] - [Advanced Chipset Control] - [Wake On Lan/PME] - [Enabled].
Select [Server] - [AC-LINK] - [StayOff].
NOTES:
[Wake On Lan/PME] feature is supported by the onboard LAN
controller (1000Base-T/100Base-Tx).
Immediately after AC power is turned on, [Wake On Lan/PME]
feature is enabled regardless of BIOS settings.
UPS
To link power supply with the UPS
To power on the server when power is supply from the UPS
Select [Server] - [AC-LINK] - [Power On].
To keep the server off-powered even when power is supplied from the UPS if the POWER
switch was used to power off
Select [Server] - [AC-LINK] - [Last State].
To keep the server off-powered even when power is supplied from the UPS
Select [Server] - [AC-LINK] - [StayOff].
Boot
To change the boot order of devices connected to the server
Select [Boot] and specify the boot order.
To display POST check results
Select [Advanced] - [Boot-time Diagnostic Screen] - [Enabled].
You can also press Esc while the NEC log is on the screen to display POST check results.
To control from the HW console
Select [Server] - [Console Redirection] and set each item.