NEC Univerge SV9100 Manual page 515

10-28
51-07-02 : NetLink Forced Change of Primary System Settings – Blade Reset

Timing Option
When the Forced Change of Primary Settings is performed, the blades in the
secondary communication servers are reset. This option determines if the
secondary SV9100 blades are reset only when all blades are idle (0) or anytime
(1).
51-08-01 : New Primary System Setting – Internet Protocol Address of New

Primary
When forcing the communications server to update to a new Primary SV9100,
the communications server using the IP address defined here as the new
Primary.
 After a Forced Change of Primary SV9100 is done, this entry is erased.
51-08-02 : New Primary System Setting – System ID of New Primary

If you already have an IP address registered in Program 51-11-03, you can
execute a Forced Change Primary SV9100 by entering the system ID. If this ID
is set to 0, the Top Priority SV9100 is selected as the new Primary.
51-09-01 : NetLink TCP Port Settings – Primary Port

Define the port the Primary SV9100 uses to communicate with the Secondary
SV9100 (0~65535).
51-09-02 : NetLink TCP Port Settings – Communication Port

Define the port used to communicate between other networked communications
servers (0~65535).
51-09-03 : NetLink TCP Port Settings – Secondary Port

This setting defines the port used by the Secondary SV9100 to communicates
to the Primary SV9100 (0~65535). If 0 is entered, the port is selected
dynamically.
51-09-04 : NetLink TCP Port Settings –Primary Search Port

When Fail-Over occurs, each SV9100 communicates with the other
communication servers using the port number specified in this entry (0~65535).
If 0 is entered, the port is selected dynamically.
If an entry other than 0 is made, up to 50 ports (depending in the number of
networked systems) are continuously used from the specified port number. (Ex:
If 5000 is entered, 5001~5049 are used.)
51-09-05 : NetLink TCP Port Settings – Primary Detection Port

Enter the port number to search for the Top Priority Primary SV9100. If 0 is
entered, the port is selected dynamically (0~65535).
51-09-06 : NetLink TCP Port Settings – Database Replication Secondary

System Listening Port
Define the listening port used so that the Secondary SV9100 can replicate the
Primary SV9100 database (0~65535).
Issue 2.0
SV9100 NetLink