Table 5-4 Voice Protocols; Programming Qos In The Univerge Sv9100 System - NEC Univerge SV9100 Manual

7.7
5-28
Table 5-3 IP Precedence and Diffserv Values Comparison (Continued)
DSCP DSCP
Decimal Binary
59 111011
60 111100
61 111101
62 111110
63 111111

Programming QoS in the UNIVERGE SV9100 System

7.7.1 Marking Voice Traffic - Program 84-10-XX
Before programming the UNIVERGE SV9100 system, discuss the
requirements with the network engineering staff or the managed network
provider. If the ToS markings that are used are not specifically configured
into the network equipment, the voice traffic is handled by the default queue
and is given lowest priority.
7.7.2 UNIVERGE SV9100 Voice Protocols
The UNIVERGE SV9100 system supports the following types of VoIP traffic
(refer to the Input Data section of Program
5-32).

Table 5-4 Voice Protocols

Number Protocol Type
1 DRS
2 Protims
3 Voice Control (H.245)
H.323
4
5 RTP/RTCP
6 SIP
7 CCISoIP
8 SIP MLT
9 SIP Trunks
10 NetLink
IP Precedence
84-10 : ToS Setup on page
Description
Not Used
Not Used
Communication from GPZ-IPLE to GPZ-IPLE
Communication from (TIE Lines) GPZ-IPLE to GPZ-IPLE
-- or --
Communication from GPZ-IPLE to Network
Voice (RTP) and Call Quality Data (RTCP)
Communication from GPZ-IPLE to Standard SIP device.
CCIS Signaling Messages
Communication from GPZ-IPLE to SIP Multiline Terminal.
Communication from GPZ-IPLE to Network
Communication from GPZ-IPLE to GPZ-IPLE
Network Design Considerations
Issue 2.0
Description