Section 5 Netlink Functions - NEC Univerge SV9100 Manual

Issue 2.0
SV9100 Networking Manual
51-06-02 : NetLink Primary System Automatic Integration Setting – Blade

Reset Timing Option
When the Primary Automatic Integration reestablishes the NetLink network, the
blades in the secondary SV9100s are reset. This option determines if the
secondary SV9100 blades are reset only when all blades are idle (0) or anytime
(1).
Other Feature Programming
Refer to the specific NetLink functions which follow for additional programs.
10-01-01 ~ 10-01-07 : Time and Date

Change the SV9100 Time and Date through SV9100 programming. Extension
users can also dial Service Code 728 to change the Time if allowed by an
extension Class of Service.
51-01-02 : NetLink System Settings – Primary Candidate Order

When the Primary SV9100 is turned off or disconnected from the network, this
value (1~50) is used to select the new Primary SV9100 with the Fail-Over
feature. The smaller the number, the higher the priority for the SV9100. When
the value for two SV9100s is the same, lower NetLink System ID (51-01-01) is
selected as the Primary SV9100.
51-01-03 : NetLink System Settings – Secondary System

The link between SV9100s is established based on this setting (0, 1). When
enabled, the SV9100 connects with the top priority Primary SV9100 (address
set in Program 51-04-01). If the SV9100 is not found within the defined time
(Program 51-05-02), the Fail-Over feature of the SV9100 searches for the
Primary SV9100 as if this option were set to 0.
The link between SV9100s is dynamically established based on the node list set
in Program 51-03-01. The Primary SV9100 is selected in the order in which the
SV9100s wake up.
51-02-01 : NetLink System Individual Setting – System Name

Set the desired site name (up to 20 characters) for ease of maintaining
information. Once the SV9100 is connected to the Primary SV9100, this setting
is updated by the Primary System data.
51-02-02 : NetLink System Individual Setting – Time Zone – Hour

Determine the offset hours from the Primary SV9100. This setting affects the
time display on display telephones (0~24 = -12 ~ +12 hours).
51-02-03 : NetLink System Individual Setting – Time Zone – Minute

Determine the offset minutes from the Primary SV9100. This setting affects the
time display on display telephones (0 ~ 120 = -60 ~ +60 minutes).
51-02-04 : NetLink System Individual Setting – System Authentication

MAC Address
When Program 51-13-03 is enabled, the SV9100 checks this MAC address
against the MAC address of the connecting CCPU. If the value is different, the
connection is refused.
51-07-01 : NetLink Forced Change of Primary System Settings – Allow Forced

Change of Primary System
When Fail-Over occurs, you can manually change the Primary SV9100 using
Program 51-08, if this option is enabled. Program 51-06-01 must be set to 0.
10-27