NEC Univerge SV9100 Manual page 610

Issue 2.0
Program 44-01-01
Program 44-02
Program 44-02-01
Program 44-02-02
Program 44-02-03
Program 44-05
Program 44-05-01
Program 44-05-02
°
Program 11-02-01 : Extension Numbering
Assign the extension numbers to the ports. The extension number can be up to eight digits long. The first/
second digit(s) of the number should be assigned in Program 11-01. This lets an employee move to a new
location (port) and retain the same extension number.
°
44-01-01 : System Options for ARS/F-Route - ARS/F-Route Time Schedule
Set this option to '0' so that the F-Route table selected is determined only by the digits dialed without any
relation to the day or time of the call.
°
44-02-01 : Dial Analysis Table for ARS/F-Route Access - Dial
Set the number of digits to be analyzed by the system for ARS routing. Using the 4-digit extension number
example in Program 11-01-01, the entry would be: Analysis Table 1: 720@@; Analysis Table 2: 723@@.
°
44-02-02 : Dial Analysis Table for ARS/F-Route Access - Service Type
Select the Service Type (0=no setting, 1=extension call, 2=ARS/F-Route table, 3=Dial extension analyze table).
Using the 4-digit extension number example in Program 11-01-01, the entry would be: Analysis Table 1: 2 (ARS/
F-Route table); Analysis Table 2: 2 (ARS/F-Route table).
°
44-02-03 : Dial Analysis Table for ARS/F-Route Access - Additional Data
Enter the additional data required for the service type selected in Program 44-02-02, either the number of digits
to be deleted or the table number to be used. Using the 4-digit extension number example in Program 11-01-01,
the entry would be: 1 (delete 1 digit).
°
44-02-04 : Dial Analysis Table for ARS/F-Route Access - Dial Tone Simulation
If enabled (1), this option sends dial tone to the calling party once the routing is determined. This may be
required if the central office at the destination does not send dial tone. Using the 4-digit extension number
example in Program 11-01-01, the entry would be: 0 (disabled).
°
44-05-01 : ARS/F-Route Table - Trunk Group Number
Select the trunk group number to be used for the outgoing ARS call (0-100, 101-150, 255 [0 = No setting, 101-
150 = Networking, 255 = Extension Call]). Using the 4-digit extension number example in Program 11-01-01,
the entry would be: ARS/F-Route Table Number 1: Priority Number 1, Trunk Group = 255; ARS/F-Route Table
Number 2: Priority Number 1, Trunk Group = 101.
°
44-05-02 : ARS/F-Route Table - Delete Digits
Enter the number of digits to be deleted from the dialed number (0-255 [255 = Delete all]). Using the 4-digit
extension number example in Program 11-01-01, the entry would be: ARS/F-Route Table Number 1: Priority
Number 1, Delete Digits = 1; ARS/F-Route Table Number 2: Priority Number 1, Delete Digits = 0.
SV9100 Networking Manual
0 (Not Used)
Table 1 Table 2
720@@ 723@@
2 2
1 2
Table 1 Table 2
255 101
1 0
0 (Not Used)
Table 1 Table 2
720@@ 723@@
2 2
1 2
Table 1 Table 2
101 255
0 1
13-15