Hot Swap; Connectors; Ethernet Status (Iple); Environmental Conditions - NEC Univerge SV9100 Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Hot Swap

The GPZ-IPLE is not hot swappable and cannot be removed from the

GCD-CP10 without first powering down the chassis and removing the

The GPZ-IPLE has the following connectors:

CN1 - RJ-45 Gigabit Ethernet LAN Interface

CN3 - Connects to the GCD-CP10

Four LEDs (two red, one green and one yellow) on the GPZ-IPLE indicate

Ethernet connection status. The yellow LED is on when the Ethernet link is

up. The green LED flashes to indicate activity and the two red LEDs are

solid to indicate 10 Base-T/100 Base-TX or 1000 Base-T link speed.

Temperature: +32 to 104 degrees Fahrenheit

Humidity: 10% ~ 90% (noncondensing)

Cable length of Ethernet cable: Up to 100m

Perform the following steps to install a GPZ-IPLE on the GCD-CP10:

Turn off the system power.

Remove the GCD-CP10, and install the GPZ-IPLE on it.

Insert the GCD-CP10 in slot 1 in the Controlling Chassis.

Figure 5-3 GCD-CP10 Blade with Daughter Board

InstalledConnect the GPZ-IPLE to the CD-RTB or to an

external switching hub using an ethernet cable. Refer to the

UNIVERGE SV9100 Programming Manual for detailed

programming instructions.

The daughter board has no switches to set.

Do not remove or install the GCD-CP10 with the power on.

SV9100 IP K-CCIS