Testing The Univerge Sv9100 Network Connection; Figure 3-5 Testing The Network Connection - NEC Univerge SV9100 Manual

S 4 T
ECTION ESTING THE
To test the UNIVERGE SV9100 network connection, it is possible to use the ICMP
(Internet Control Message Protocol) Ping command. This basically sends a small
amount of data from one device to another and then waits for a reply. This test
confirms that the IP addressing and physical connection are good. To perform this
test, from a Windows PC:
1.
2.
3.
4.
5.

Figure 3-5 Testing the Network Connection

system has replied to the Ping request – this indicates that the UNIVERGE SV9100
system is correctly connected to the network.
3-8
UNIVERGE SV9100 N
Click Start.
Click Run... .
In the Open dialogue box, enter command.
Click OK. A Command prompt window opens.
Type ping 192.168.1.200.
Figure 3-5 Testing the Network Connection
C
ETWORK ONNECTION
shows that the UNIVERGE SV9100
General IP Configuration
Issue 2.0