Table 7-1 H.323 Setup Assignments; Configure Voipdb Trunk Ports - NEC Univerge SV9100 Manual

Issue 2.0
2.2

Table 7-1 H.323 Setup Assignments

Program/ Description/
Item No. Selection
IP Trunk Availability – Trunk
Type
10-68-01
IP Trunk Availability – Start
10-68-02 Port
IP Trunk Availability –
10-68-03
Number of Ports
Trunk Group – Trunk Group
Number
14-05-01
Incoming Call Trunk Setup
22-02-01
SV9100 Networking Manual

Configure VoIPDB Trunk Ports

After installing IPLE (VOIP Daughter Board) in UNIVERGE SV9100 System,
VOIPDB trunk ports need to be defined in 10-68-01.
By default the VOIPDB trunk ports are defined as None. When using H.323, you
need to change the trunk ports to H.323 in 10-68-01.
2.2.1 H.323 Setup
Use the following programs to assign the information for H.323.
Assigned Data
0: None
1: SIP
2: H.323
3: CCIS
Range: 0 ~ 400
Default is 0
Range: 0 ~ 400
Default is 0
0~100
Priority = 1 ~ 400
Default is Group 1
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie Line
6 = Delayed VRS
7 = ANI/DNIS
8 =DID(DDI) Mode Switching
Default is 0
Comments
Assign the H.323 Trunk Availability
Assign the start port number of H.323
Trunks
Assign the Number of H.323 Trunks
Default priorities for trunks 1~400 is
1~400.
Assign Trunks to Trunk Groups/
Outbound Priority
Set the feature type for the trunk you
are programming.
(Second dial tone for option 1 if no
VRS is installed)
7-3