NEC Univerge SV9100 Manual page 443

Program
Program Name
Number
DT800/DT700
Server Information
10-46-01
Setup – Register
Mode
DT800/DT700
Server Information
10-46-04 Setup – Server
Name
DT800/DT700
Server Information
10-46-06 Setup – Register
Port
DT800/DT700
Server Information
10-46-07
Setup – Encryption
Mode
8-52
Description/Comments
Define which of the three
Registration modes you wish the
SIP MLTs to use.
Normal
When the phone boots up it will
report the ext assigned in the phone
or choose the next available
extension in the system. No
password required.
Auto
If set to auto then the SIP user
name and password must be
entered into the actual IP phone.
These settings have to match
Programs 84-22/15-05-27 or the
phone does not come on-line.
Manual
When the phone boots up it prompts
you to enter a user ID and password
before logging in. It checks this user
ID/password against Programs 84-
22/15-05-27. If there is not a match,
the phone does not come on-line.
USER ID of the SIP URL if Program
10-46-05 is set to domain name.
A SIP URL is made up of three
parts. Domain name, host name,
and server name.
e.g. At default the server name is
sipphd. The URL could look like the
following:
sipphd@voipu.nec.com
Port the SIP messages are sent to
on the VoIPU card. This same port
number must be assigned in the SIP
Multiline terminals.
Changing this command also
requires a CPU reset.
Enable or disable encryption mode.
Assigned Data
0 = Normal
1 = Automatic
2 = Manual
Default is 0
Up to 32 characters.
Default is sipphd
Range = 0 ~ 65535
Default is 5080
0 = Off
1 = On
Default is 0
IP Multiline Station (SIP)
Issue 2.0
1 2 3
X
X
X
X