Ccis Assignment; Table 3-2 Ccis Programming Assignments - NEC Univerge SV9100 Manual

Issue 2.0
1.2
Program/
Item No.
50-01-01
50-02-01
50-02-02
50-02-03
50-02-04
50-02-05
50-04-01
14-14-01
SV9100 Networking Manual

CCIS Assignment

Use these programming assignments to set the availability of CCIS.

Table 3-2 CCIS Programming Assignments

Description/
Selection
CCIS System Setting –
CCIS Availability
Connecting System
Settings – Port Number of
Common Signaling
Channel (T1)
Connecting System
Settings – Common
Signaling Channel Data
Speed Assignment (T1)
Connecting System
Settings – Originating
Point Code
Connecting System
Settings – Destination
Point Code (T1)
Connecting System
Settings – Calling Name
Indication (T1)
CCIS Office Code
Assignment – CCIS Office
Code
CCIS Trunk CIC
Assignment – Trunk
Group Number 1~200
Assigned Data
0=Disable
1=Enable
Default is 0
0~400
Default is 0
0=64Kbps
1=56Kbps (Default)
2=48Kbps(1)
3=48Kbps(2)
Default is 1
0 ~ 16367
Default is 0
0 ~ 16367
Default is 0
0=Disable
1=Enable
Default is 1
Assign up to four
digits.
Default is No Setting
0 = Not Assigned
1~127 = CIC Numbers
Default is 0
Comments
Any CCIS settings lose
functionality if this setting is set
to 0.
Specify the Trunk port to send
D-channel information. This
program is available for using
DTI package.
If 56K K-CCIS is used (1), 24
Multi-Frame (ESF) must
be assigned in PRG 10-03-02.
Default settings for each CCIS
Route ID is not assigned.
This Program is for DTI Only
and must be the same for all
CCIS Route IDs.
DPC must be what
the OPC is on the
opposite side of the
link.
Enable to receive name display
across K-CCIS.
Only used in an open
numbering plan network. This
should include the Trunk
Access Code and Office Code
number.
Assign a Circuit Identification
Code (CIC) number to each
trunk number used for voice
channel.
3-3