Chapter 4 Programming - NEC Univerge SV9100 Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

This chapter provides you with detailed information about the UNIVERGE SV9100

program blocks that may be required to connect the SV9100 to a data network and to

configure the VoIP function. The configuration and programming examples, found in

the earlier chapters, can be a useful reference when programming the data.

When using this chapter, note that the information on each program is subdivided

into the following headings:

Description describes what the program options control. The Default Settings for

each program are also included. When you first install the system, it uses the Default

Setting for all programs. Along with the Description are the Conditions which

describe any limit or special consideration that may applies to the program.

The reverse type (white on black) just beneath the Description heading is the

program access level. You can use only the program if your access level meets or

exceeds the level the program requires. Refer to

Programming Mode on page 4-2

Feature Cross Reference provides you with a table of all the features affected by

the program. You should keep the referenced features in mind when you change a

program. Customizing a feature may have an effect on another feature that you did

Telephone Programming Instructions shows how to enter the program data into

system memory. For example:

To enter the programming mode:

SV9100 Networking Manual



Dial 150701 from the telephone dial pad. See the message 15-07-01 TEL on the

first line of the telephone display. This indicates the program number (15-07), item

number (01), and that the options are being set for the extension.

Section 2 How to Enter

for a list of the system access levels and