Card Interface Slot Assignment (Prg 10-03); Digital Trunk Assignments - NEC Univerge SV9100 Manual

Issue 2.0
Card Type During 1st
Slot
Power On
1 GCD-CP10/GPZ-IPLE
2
GCD-8DLCA
3
GCD-8DLCA
4 None
5
GCD-4COTC
6 None
SV9100 Networking Manual
3.1.1

Card Interface Slot Assignment (PRG 10-03)

The following slot assignments were set using program 10-03.
System A
Card Type
GCD-CP10/GPZ-IPLE
GCD-8DLCA
GCD-8DLCA
None
GCD-4COTC
None
3.1.2

Digital Trunk Assignments

This example shows digital trunk assignments made for systems A and B.
System A
Program 10-03-01
Insert GPZ-IPLE on GCD-CP10 in Chassis 1, Slot
1.
Verify PRG 10-03-01 (ETU Setup)
Program 10-19-01
Assign DSP Resources 001~024 as CCIS (LK4).
Program 10-68-01
Assign the Trunk Type as CCIS
Program 10-68-02
Assign the Start Port as 5
Program 10-68-03
Assign 24 as number of ports
Program 14-05-01
Assign Trunks 5 ~ 28 in Trunk Group 10
Program 22-02-01
Set Trunks 5 ~ 28 as Tie Line (LK6).
CARD TYPE AND PORTS
Ports Card Type
~
Trunks 5 28 GCD-CP10/GPZ-IPLE
~
Station 1 8 GCD-8DLCA
~
Station 9 16 GCD-8DLCA
N/A None
~
Trunks 1 4 GCD-4COTC
N/A None
Program 10-03-01
Insert GPZ-IPLE on GCD-CP10 in Chassis 1,
Slot 1.
Verify PRG 10-03-01 (ETU Setup).
Program 10-19-01
Assign DSP Resources 001 ~ 024 as CCIS
(LK4).
Program 10-68-01
Assign the Trunk Type as CCIS
Program 10-68-02
Assign the Start Port as 5
Program 10-68-03
Assign 24 as number of ports
Program 14-05-01
Assign Trunks 5 ~ 28 in Trunk Group 10.
Program 22-02-01
Set Trunks 5 ~ 28 as Tie Line (LK6).
System B
Ports
~
Trunks 5 28
~
Station 1 8
~
Station 9 16
N/A
~
Trunks 1 4
N/A
System B
5-33