Manual Registration - NEC Univerge SV9100 Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Network Settings

DHCP Mode - DHCP Disable. Click OK.

IP Address - Enter the IP Address for the station, and click OK.

Default Gateway - Enter the Default Gateway Address, and click

OK. If you are testing without a router/gateway, this must be left at

the default 0.0.0.0.

Subnet Mask - Enter the Subnet Mask for the station, and click OK.

SIP Settings

Server Address & URI - 1

Enter the IP address assigned in command 10-12-09, and click

SIP Server Port - 1

Enter port 5080. Click OK.

Press the EXIT key until you are back at the Main menu.

Press the SAVE key, and the phone saves the configuration to

memory, reboots itself and registers with the CPU.

15.8.3 Manual Registration

The station does not require an Ethernet connection to

enter program mode. Only power is required. Power

can be provided by an AC adapter plugged into the

phone or by POE provided by a data switch. If the data

switch is providing POE it MUST be using the 802.3af

For Basic bench testing only the following assignments

are required:

Press 0 on the dial pad for configuration mode.

You are prompted with a User Name and Password.

The defaults are:

User Name: ADMIN

Password: 6633222

The user name should already be entered in the

Press Set soft key to step down to the password field.

After you enter the password, press the OK soft key.

User ID - Enter User ID assigned in command 84-22.

Password - Enter the password assigned in command 84-22.

Incom Number - Enter the extension number for the IP

Server Address

IP Multiline Station (SIP)