How To Enter Programming Mode - NEC Univerge SV9100 Manual

Issue 2.0
sion . The second row of the display "KY01 = *01" indicates that Key 01 is being programmed
with the entry of *01. The third row allows you to move the cursor to the left or right, depending on
which arrow is pressed. To learn how to enter the programming mode, refer to 4.3) How To Enter
Programming Mode below.
4.3

How to Enter Programming Mode

To enter programming mode:
1. Go to any working display telephone.

In a newly installed system, use extension 101 (port 1).
2. Do not lift the handset.
3. Press Speaker.
4. * * .
# #
Password
5. Dial the system password + Transfer.
Refer to the following table for the default system passwords. To change the passwords, use
02 : Programming Password
Password
------
12345678
0000
9999
SV9100 Networking Manual
Setup.
User
Level
Name
------ 1 (MF) Manufacturer (MF):
All programs
tech 2 (IN) Installation (IN):
All programs in this section not listed below for SA and
SB
ADMIN1 3 (SA) System Administrator – Level 1 (SA):
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17,
10-18, 10-22, 12-02, 12-03, 12-04, 15-01, 15-07, 15-09,
15-10, 15-11, 20-16, 21-07, 21-14, 22-04, 22-11, 25-08,
30-03, 32-02, 40-02, 41-02, 41-03, 41-04, 41-05, 41-06,
41-07, 41-08, 41-09, 41-10, 41-11, 41-12, 41-13, 41-14,
41-15, 41-16, 41-17, 41-18, 90-03, 90-04, 90-06, 90-07,
90-18, 90-19
4 (SB)
ADMIN2 System Administrator – Level 2 (SB):
13-04, 13-05, 13-06
Programs at this Level
90-
13-55