NEC Univerge SV9100 Manual page 541

Use this key...
MIC
LINE KEYS
LINE KEY 1
LINE KEY 2
LINE KEY 3
VOL
VOL
10-54
Table 10-4 Keys for Entering Data (Continued)
When you want to...
Press MIC
moves up to the top row of the display. Press
cursor back to the middle row.
Use programmed settings to help with the program entry. These settings
vary between programs from LINE 1 = 0 (off) and LINE 2 = 1 (on) to preset
values for timers where LINE 1 = 5, LINE 2 = 10, LINE 3 = 15, etc.
For programs with this option, the line key, which currently matches the
programmed setting, lights steady.
The display can also indicate Softkey, which will allow you to select the
values as well (-1 and +1 will step through these pre-programmed
settings.)
Program a pause into a Speed Dialing bin.
Program a recall/flash into a Speed Dialing bin.
Program an @ into a Speed Dialing bin.

Scroll backward through a list of entry numbers (e.g., from extension
etc.) or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data
before scrolling forward.

Scroll forward through a list of entry numbers (e.g., from extension
etc.) or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data
before scrolling backward.
Keys for Entering Data
to switch between the different input data fields. The cursor
Issue 2.0
MIC again to move the
SV9100 NetLink