NEC Univerge SV9100 Manual page 613

set call forward to an F-Route number. The full digit length must be set in Program 11-01 to allow the user to
enter the full F-Route destination number.
For example if 11-01 was set to 1 digit number length in the example above a user who sets call forward can only
enter 1 digit as the destination (e.g 741+1+7). This would cause all calls to the extension to fail whilst the call
forward is set to an invalid destination number.
Notice : When a call is routed via AspireNet by using F-Route the dialed digits MUST be translated otherwise the call
will not 'exit' from the F-Route tables.
Notice : When an AspireNet call is routed via F-Route it is possible to translate the dialed digits at either (or both)
the originating or destination system. Programs 44-05-02 (Delete digits) and 44-05-03 (Additional Dial Table)
are available for digit translation.
Related Programs
13-18
Program Number
11-01
Numbering Plan
44-01
System Options for F-Route Service
44-02
Dial Analysis Table for F-Route Access
44-04
F-Route Selection for time schedule
44-05
F-Route Table
44-06
Additional Dial Table
44-07
Gain Table for F-Route Access
44-08
Time Schedule for F-Route Service
44-09
Weekly Schedule for F-Route Service
44-10
Holiday Schedule for F-Route Service
Title
Issue 2.0
AspireNet