Table 10-5 Keys For Entering Names - NEC Univerge SV9100 Manual

Issue 2.0
S 21 P
ECTION ROGRAMMING
Several programs (e.g., Program 20-16 : Selectable Display Messages) require you
to enter text. Use the following chart when entering and editing text. When using the
keypad digits, press the key once for the first character, twice for the second
character, etc. For example, to enter a C, press 2 three times. Press the key six times
to display the lower case letter. The name can have up to 12 digits.
Use this keypad digit . . . When you want to. . .
SV9100 Networking Manual
N
AMES AND

Table 10-5 Keys for Entering Names

1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
Enter characters: A-C, a-c, 2.
2
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! "
Enter characters:

 +
= Accepts an entry (only required if two letters on the same key
#
#
are needed – ex: TOM). Pressing
programming mode, use the right arrow Softkey instead to accept
and/or add a space.)
Conf Clear the character entry one character at a time.
Hold Clear all the entries from the point of the flashing cursor and to the
right.
T M
EXT ESSAGES
 
#
$ % & ' (
, - . / : ; < =
Á À Â Ã Ç É Ê ì ó

) ô Õ ú ä ö ü

? B E S
>
again = Space. (In system
#
¢ £
10-55