Right Front Turn Signal Output Short - Chrysler Town and Country 2003 Owner's Manual

EXTERIOR LIGHTING
Symptom:

RIGHT FRONT TURN SIGNAL OUTPUT SHORT

When Monitored and Set Condition:
RIGHT FRONT TURN SIGNAL OUTPUT SHORT
When Monitored: Anytime the IPM is active.
Set Condition: When output voltage status is Low.
INTERMITTENT CONDITION
RIGHT FRONT TURN SIGNAL OUTPUT SHORT TO GROUND
TURN SIGNAL LAMP
INTELLIGENT POWER MODULE
TEST
1 Turn the ignition on.
With the DRBIII , clear all IPM DTC's.
Actuate the Turn Signals.
With the DRBIII , read the DTC information.
Does the DRBIII read: Right Front Turn Signal Output Short?
Yes → Go To 2
→ The condition that caused the symptom is currently not present.
No
2 Turn the ignition off.
Disconnect the Right Front Turn Signal Lamp connector.
Disconnect the IPM harness connector.
Measure the resistance between the Right Front Turn Signal Output circuit and
ground.
Is the resistance below 100.0 ohms?
Yes → Repair the Right Front Turn Signal Output circuit for a short to
→ Go To 3
No
POSSIBLE CAUSES
ACTION
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced,pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
484
APPLICABILITY
All
All