Chrysler Town and Country 2003 Owner's Manual page 179

PASSENGER SQUIB 2 SHORT TO GROUND —
TEST
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger Airbag connector(s).
NOTE: Check connectors - Clean and repair as necessary.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Connect the appropriate Load Tool to the Passenger Airbag connector(s).
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag Control Module DTC's.
Does the DRBIII show PASSENGER SQUIB 2 CIRCUIT SHORT TO GROUND?
Yes → Go To 3
→ Replace the Passenger Airbag in accordance with the Service
No
3 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Disconnect the Load Tool from the Passenger Airbag connector(s).
Disconnect the Airbag Control Module connector(s).
NOTE: Check connectors - Clean repair as necessary.
Connect the appropriate Load Tool Adaptor to the Airbag Control Module connec-
tor(s).
Measure the resistance of the Passenger Squib 2 Line 1 and Line 2 circuits between
the Passenger Airbag Module connector and ground.
Is the resistance below 10K ohms on either circuit?
Yes → Repair Passenger Squib 2 Line 1 or Line 2 circuit for a short to
→ Replace the Airbag Control Module in accordance with Service
No
ACTION
Information.
Perform AIRBAG VERIFICATION TEST - VER 1.
ground.
Perform AIRBAG VERIFICATION TEST - VER 1.
Information. WARNING: IF THE AIRBAG CONTROL MODULE
IS DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
155
AIRBAG
APPLICABILITY
All
All